Talking turkey (pattern instructions)
(PDF version here)
- Spool loom or 2 pegs on any loom for I-cord
- 24 peg loom (KK blue loom)
- 12 peg loom(KK flower Loom)
- Small amounts single strand 4 ply yarn (gold, dark brown, black, red and variegated fall colors for tail feathers)
- 1" Styrofoam ball for head
- Low temp glue & gun
- Google eyes
- 12" chenille stem (brown or black) for feet
- Fiberfill stuffing
- Size G crochet hook
- Yarn Needle
- With the 12-peg flower loom and gold yarn do the drawstring cast on.
- Knit in the round for 31 rows.
- Draw up and close the cast on edge.
- Work a gathered bind off on the last row; tie off and remove from loom leaving an 8” yarn tail at end.
- Stuff and close up bottom end; thread yarn tail onto yarn needle and stitch up thru middle of body and back down several times. Pull tight to make indentation. Tie off.
- Using variegated fall colored yarn and the 24-peg large gauge loom work a drawstring cast on.
- Knit for 12 rows.
- Cinch the drawstring yarn tail to close the cast on edge and tie off.
- After completing row 12, cut the working yarn leaving a yarn tail long enough to wrap around the loom plus about 4” extra. Bind off by threading a yarn needle with the long yarn tail then sewing up thru the loops and taking them off the pegs. Tie off very loosely.
- After removing from the loom, stretch out other end (see the Ghost Angel wing directions) to make a flat circle shape; fold circle in half to make crescent shape; sew up open edges loosely and sew completed tail to back of body above the center bind off indention. Spread out like a fan.
- Using the spool loom or two pegs of any loom and dark Brown yarn make an I-Cord for 8 rows.
- Bind off and leave yarn tails at both ends.
- Sew one end to center of body where indentation is and other end to top of body where the head will go.
- With the 12 peg loom and dark brown yarn work a drawstring cast on.
- Knit for 6 rows.
- Cinch the drawstring yarn tail from the cast on edge close and tie off.
- Do a gathered bind off after finishing row 6 and leave a yarn tail at end. Remove from the loom, but do not close the bind off edge shut.
- Insert 1" foam ball into the head and draw up the bind off yarn tail tight around the ball and sew whole thing to top of body at top of neck.
One 12" chenille stem. Fold a little bit of the stem so you can hook it to a big yarn needle and thread it thru the bottom of the body (with the needle) for the feet. Bend both the ends of the stem to look like toes (see photo below).
Using a crochet hook and the gold yarn, chain 3 and double crochet three times in third chain from hook. Slip stitch into top of chain three. Leave yarn tail and sew to front of head. (Note: If you cannot crochet, you can work a 3 row I-cord and shape it to make the beak.)
With the crochet hook, chain 4 with red yarn. Sew to side of beak. Glue on eyes to each side of beak.
Make long loose stitches with YARN NEEDLE in dark brown yarn 6 or 7 times in same spot on either side of body. Spread stitches out to look like wings.
One short length of black yarn (about 5 1/2 " long) folded in half and sewed to front of neck.With yarn needle,separate the 4 ply stands of the yarn, fluff a little, and trim. Pull the beard into position in the center front of the turkey.
Make a “back support stitch” with yarn needle and dark brown yarn several times at the bottom back of body to make ledge to support the body and keep it from tipping over. (Note: I use Poly Pellets, which is available at most craft stores where stuffing is sold, in the base when stuffing toys for added base weight.)